4 - 7
SOFTWARE ADJUSTMENT – continued
Select an item using [CH-UP] / [CH-DN] buttons, then set specified value using [RPT/BASE] / [MONI] buttons on the
FRONT PANEL.
1
2
1
2
• LCD display :
A06 HW POWER
• Operating freq. : 160.2750 MHz
[GEN74]
162.2750 MHz [Other]
• Connect the RF power meter to the [TX]
antenna connector.
• Transmitting
• Push the [PROG] button
• LCD display :
A06 LW POWER
• Operating freq. : 160.2750 MHz
[GEN74]
162.2750 MHz [Other]
• Transmitting
• LCD display :
A07 LW M DEV
• Operating freq. : 160.2750 MHz
[GEN74]
162.2750 MHz [Other]
• IF bandwidth : Wide
• Connect the audio generator to the
[MIC] jack through the JIG cable and set
as:
1.0 kHz/40 mVrms
• Set an FM deviation meter as:
HPF : OFF
LPF : 20 kHz
De-emphasis: OFF
Detector : (P–P)/2
• Transmitting
• LCD display :
A08 LW LMODC
• Operating freq. : 148.2750 MHz
[GEN74]
150.2750 MHz [Other]
• IF bandwidth : Wide
• Connect the audio generator to the
[MIC] jack through the JIG cable and set
as:
1.0 kHz/40 mVrms
• Set an FM deviation meter as:
HPF : OFF
LPF : 20 kHz
De-emphasis: OFF
Detector : (P–P)/2
• Transmitting
• LCD display :
A09 LW HMODC
• Operating freq. : 171.7250 MHz
[GEN74]
173.7250 MHz [Other]
• Transmitting
Rear
panel
Rear
panel
Rear
panel
Connect the RF power meter to
the [TX] antenna connector.
Connect the FM deviation meter
to the [TX] antenna connector
through the attenuator.
Connect the FM deviation meter
to the [TX] antenna connector
through the attenuator.
50.0 W
[Other]
25.0 W
[EUR2], [FRG2]
10.0 W
[Other]
5.0 W
[EUR2], [FRG2]
±4.4 kHz
[Other]
±3.5 kHz
[FRG2]
±4.4 kHz
[Other]
±3.5 kHz
[FRG2]
±4.4 kHz
[Other]
±3.5 kHz
[FRG2]
ADJUSTMENT ADJUSTMENT CONDITION
MEASUREMENT
VALUE
UNIT LOCATION
*The output level of the standard signal generator (SSG) is indicated as the SSG’s open circuit.
OUTPUT
POWER
(HI)
(LOW)
DEVIATION
MODULATION
BALANCE
(LOW FRQ.)
(HIGH FRQ.)
Kommentare zu diesen Handbüchern